The electric fence for animals is neither dangerous for people nor for animals. As with everything, even for electric fences there is a standard that establishes the values ​​to be respected. The fence energiser is a product that emits intermittent pulses with a low amperage.

To create an electric fence for animals you need: a Gemi energiser - 100% Made in Italy - for fences that carries the current to the fence, an electrified conductor wire for the fence and insulators for electrified fences screwed on the posts to hold the wire.

With the current model we supply: grounding cable and cable with tweezers to be connected to the fence. With the dual power model, we provide a 220V power supply, cables for connections to the car battery (positive and negative), a grounding cable and a cable with tweezers to be connected to the fence.

Grounding is a fundamental thing for the functionality of the electric fence for animals, so it is recommended to do it correctly. To have the total discharge of current by the energiser, it is necessary to make the grounding by inserting 3 galvanized poles of 1 meter in the ground. They must be positioned 3 meters apart, 80 cm in the wet ground and 20 cm outside, and then connect them with the yellow cable. Together with the electric fence, we supply only 1 meter of cable that must be connected to the first pole. It is recommended to do it where there is the presence of vegetation, therefore a moist soil. Arid soil is not conductive. According to the tests carried out, placing 3 poles in any type of terrain, there will be no problem with functionality. If you put only one stake, the power of the current felt will be less than its range and the animals will be able to cross the fence.

For a B12 energiser it is sufficient to use a 12V 40Ah car battery. The autonomy, if there is no dispersion in the electric fence, is about 10/12 days. Otherwise it lasts less.

If the current is far from the electric fence, for your Gemi energiser - 100% Made in Italy -, we have the high-voltage crossing cable that can work on the surface or underground, without discharging. With this cable it is possible to carry current on the fence, without any dispersion. The cable for electric fences can also be used to join two fences, then connect one end to a first fence and the other end to a second fence, when there is little distance between one fence and another.

To check if there is current on the electric fence for animals, just bring the tip of a screwdriver with an insulated handle a few mm away from the fence wire. The moment you hear a ticking, it means that there is current on the electric fence.

The signal lights that flash alternately on the energiser for electric fences indicate the correct operation of the appliance.

An energiser cannot be outdoors. It must be kept indoors to prevent it from being damaged by bad weather.

An energizer cannot be kept outdoors. It must be kept indoors to prevent damage from the weather. In order to discharge all its current, it must be earthed by inserting 3 galvanized 1 meter stakes into the ground. They must be placed 3 m apart, 80 cm in the ground (wet) and 20 cm outside, and then connected with the yellow-green cable. The device has a red positive cable at its output which is connected to the fence and a yellow-green cable which is connected to the first ground stake. Never connect two electrifiers to the same wire, as the two impulses may cancel each other out, causing problems. You can connect two electrifiers to the same fence, but keep them on two separate lines of wire.